Tried what you suggested Gary. No joy. The upper limit with the PWR knob remains at 0.8MW. I can adjust downward but not upward. Need to get a good power meter on it and see what the actual output is. And, I’ll try the low-level power calibration process and see what happens.
Thanks again. Any others have any suggestions? David, NS4V > On Feb 27, 2022, at 3:21 PM, Gary Johnson <g...@me.com> wrote: > > Sounds like you should do the low-level power calibration using the K3 > Utility. For now, you can increase the maximum, up to 1.5 mW, and presumably > get the desired output. > > Gary NA6O > >> Using the Config Menu, I have set the drive level at the maximum for the >> transverter at 1 MW. However, when I check the drive from the front panel >> PWR knob it reads 0.8MW and I cannot adjust it any higher with the knob. >> Nothing I do seems to change the the PWR knob drive level. I am running SSB >> on 432.095. >> >> Any suggestions would be most appreciated. >> >> Tnx es 73, >> >> NS4V NS4V David R. Hourdequin, PE 828-421-6216 d...@dremy.com www.dremy.com ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com