----- Original Message -----
From: "Don Wilhelm" <[EMAIL PROTECTED]>
To: "Roy Morris" <[EMAIL PROTECTED]>; <elecraft@mailman.qth.net>
Sent: Monday, August 14, 2006 11:44 PM
Subject: RE: [Elecraft] Proper Adjustment of K2 AGC
Thanks Don. Yes, I had a senior moment on the resistor value. I think the
procedure for setting the AGC threshold should be incorporated in the
manual. This is very important in obtaining optimum performance from the K2
receiver. Thanks again for your excellent info. Roy
You must have misread something (or did a typo). The stock value for
Control Board R1 on the older boards is 51k.
Roy,
You must have misread something (or did a typo). The stock value for
Control Board R1 on the older boards is 51k. A 50k pot will do the task
for you, or a 20k pot in series with a 33k resistor. I typically find
that
a 39k, 36k or 33k resistor will set the proper level, but I have also
found
that the stock 51k value is OK in some cases. I would hesitate to go
below
33k at R1 because as I have mentioned before, the S-meter settings (and
readings) become 'funny' (that is tech-speak for too critical).
I have not yet discovered a concise set of parameters for determining what
the value should be, but I do know that the exact output from the 8 volt
regulator is a large factor - if you have 8.2 volts or more from the
regulator, the stock value is likely correct. I suspect (but cannot
substantiate nor quantify) that there are minor dfferences in the gain vs.
AGC voltage at the IF amp chip that also come into the picture.
Your procedure is correct, but I would recomend the smaller value for the
pot - the 100k will work, but the adjustment will be more 'touchy'
compared
with a smaller value. Set it to the point where the AGC ON noise is just
barely discernable from the AGC OFF.
73,
Don W3FPR
-----Original Message-----
After reading Don's (W3FPR) AGC procedure, curiosity got the best
of me. I set up my parameters as he stated and was surprised to
find a considerable difference between AGC ON and AGC OFF with
AGC OFF being considerably louder. I am going to remove R1 (71K)
from the Control Board and substitute a pot to find the proper
resistance value. I understand this pot should be adjusted to
where the AGC ON and OFF should be just about the same with the
RF gain set fully clockwise. If I remember correctly a 100K pot
should be used to establish the value of R1. Is this the correct
procedure? Roy Morris W4WFB
--
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.1.405 / Virus Database: 268.10.10/419 - Release Date: 8/15/2006
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.1.405 / Virus Database: 268.10.10/419 - Release Date: 8/15/2006
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
