Have you connected both the RJ45 data cable and a separate power cable? On Wed, Nov 15, 2023, 05:35 <sem...@semaos.plus.com> wrote:
> Hi All, I have taken my Kpod from my K4 and put it on my K3. (I assume it > works for both rigs). > > The K3 has had the Mod completed as per the Kpod manual with a 6.8 Ohm, 1/8 > W Leaded Resistor as per pages 16-18 of the Kpod manual. > > Problems. > > 1. Kpod does not power up with the Data cable between K3 & Kpod > connected (No leds lit up at all. > 2. When I power Kpod with a 12v source the On led shows as does D1 - > D3 > when switched with the rocker switch. > 3. The large tuning knob on the Kpod does not function in any way. > > > > I have tested the Data cable with a network tester it is wired correctly > 2-6 > pins only and they show satisfactory on the tester. > > I have tried programming Macros and saved to K3 accordingly but the Kpod > doesn't activate any of them. > > > > Anyone have any ideas of possible problems that a dummy can fix or try at > home please? > > > > TIA > > Chris G0TZZ > > ______________________________________________________________ > Elecraft mailing list > Home: http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/mmfaq.htm > Post: mailto:Elecraft@mailman.qth.net > > This list hosted by: http://www.qsl.net > Please help support this email list: http://www.qsl.net/donate.html > Message delivered to k1ep.l...@gmail.com > ______________________________________________________________ Elecraft mailing list Home: http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/mmfaq.htm Post: mailto:Elecraft@mailman.qth.net This list hosted by: http://www.qsl.net Please help support this email list: http://www.qsl.net/donate.html Message delivered to arch...@mail-archive.com