On September 07, 2006 3:00 AM, Darrell VA7TO wrote
I too see the occasional "High Current" reading at the beginning of a
transmission. Switching to the "Voltage/Current" display shows current
well
under the current limit setting.
Looks like I am currently having problems with RF getting into my DC power
system. I suspect that this might be the cause of the "High Current"
reading
blips.
------------------------------------------------------
FWIW I have seen the same thing when running my K2/100 into a dummy load
connected to Ant 2 of my KAT100, usually during a "transmission" of dits or
voice modulated SSB. Could the cause be RF *inside* the K2/100's enclosure
getting into the K2's digital circuits?
73,
Geoff
GM4ESD
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
