Chuck, If you get the "not inst" message it means that the KDSP2 is not being recognized. The fact that it is intermittent indicates that there is a bad solder connection somewhere. You might try re-flowing the solder on the KDSP2 board.
73, Don W3FPR > -----Original Message----- > > I assume you mean the rtc (real-time clock). It is on (or at least starts > out that way, with power on). However, after some time of > operation, I get > "not inst." The DSP filters work fine-- I just can't call them up in the > menu to edit them or make changes without doing the power on/off. > > So far have not heard from Elecraft support on this. > > 73, > Chuck NI0C > > -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.432 / Virus Database: 268.15.18/585 - Release Date: 12/13/2006 11:49 AM _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com