Gil,

OK, your K2 is rebelling from non-use - feed it some electrons once in a while 
<G>

On the INFO 080 situation - that is a problem caused by one of the devices 
(options) attached to the AUXBUS signal.  Turn the manual to the 
troubleshooting section for problem 080 and follow through from there.

On your key problem - try again.  Also go into the menu and verify that you 
still have INP Hand.  If you are not successful with that, try connecting the 
tip and ring together at the plug to the key - that should permit the 
AUTO-Detect feature to be active unless you have turned it off in the menu.

73,
Don W3FPR
  -----Original Message-----
  From: Gil Stacy [mailto:[EMAIL PROTECTED]
  Sent: Sunday, December 31, 2006 11:25 AM
  To: [EMAIL PROTECTED]
  Cc: William Koucky; elecraft@mailman.qth.net
  Subject: Straight Key issues on K2




  After a couple of months of not turning on K2, it has gone goofy.  Apparently 
  goofiness caught from OP by K2.
  With HAND selected in INP menu, straight key properly wired, starts string of 
dits when contacts closed.  Same key I"ve used for 4 years without a problem.  
Tried another, same thing.  
  After turning on set, INFO 80 msg. appeared.  Restart, msg. disappeared.  
Series of restarts normal.  If I had to guess, bad solder joint.  Unlike wine, 
solder joints do not get better with age. Question is, where to start? 

  73, Gil NN4CW
  K2 3104
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

Reply via email to