Ok, I'm at VCO alignment now :) Problem is that moving L30's slug around doesn't change the reading on R30, it stays at 8V. My T5 *looks* good to me. The manual says refer to troubleshooting but I didn't see anything there that would get me in the ballpark.
I've checked solder joints in the vicinity and don't see anything obvious. I've searched through the archives and the only hit I see is someone who had a bad solder joint that would cause the voltage on R30 to be at the 8V rail. Any more ideas? Thanks, -J _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
