Jim, Those are the 5 kHz transitions from the PLL.
First check the resistance across RFC15 on the bottom of the RF Board - it should be quite low. If it is open and you do not have an immediate replacement, place a shorting jumper across it. If RFC15 is OK and you still have the clicks, re-run CAL PLL. Be certain the bottom cover is in place when running CAL PLL. 73, Don W3FPR > -----Original Message----- > > As I tune the K2 across the band I get periodic little "blips". > They aren't > birdies and they don't hinder reception. As I sit either side of the > frequency where the blip occurred there is no apparent signal or > interference. They actually tic the S-meter a few notches as > well. The blip > occurs when the display changes from 3-4 on the least significant freq > digit. So there's really no way to "sit" on the frequency. > > I'm guessing this has to do with the way the PLL and VFO tuning interact. > > Is it normal to hear such little blips? Or do I need to do some debugging? > > Currently I get it at 7014.73 as I transition to .74. > > Likewise at 7019.73-74, 7024.73-74 and 7029.73-74. > > -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.432 / Virus Database: 268.17.8/648 - Release Date: 1/23/2007 11:04 AM _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
