Hi John,
I mis-spoke. I meant to say that I want the 28 mhz receive out of the
transverter, not the 144 mhz receive, while keeping the 144 mhz RX/TX
on the single output port connector.
At 02:08 1/31/2007, you wrote:
I suppose you could install W2, but I think you'd end up with
impedance issues. You're better off removing the T/R relay and using
an external relay, with a correctly designed network (and probably a
gain stage to compensate for the lost dbs) ..
or, you could do it on the 28Mhz side .. that's what I'm planning on
doing this spring :)
de w1rt/john
On 1/30/07, Dave Blaschke <[EMAIL PROTECTED]> wrote:
My transverter is set up to TX and RX on the same output connector.
Is it possible to configure so that I can retain this RX/TX as is and
have another port give me 144 mHz RX only output? I need this
capability in order to interface the transverter to my SDR-IQ SDR,
which is a receive only radio.
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
