FB, it was just that we had grounded all the other cans, so I wasn't
sure. Thanks.
David Wilburn
[EMAIL PROTECTED]
Don Wilhelm wrote:
Dave,
Congratulations on your progress.
Don't worry about the empty holes - all holes are not filled, many are via
holes to get a signal (or ground) from the top of the board to the bottom.
If you need to check anything else of that nature, look at the parts
placement diagram near the end of the manual, you will find it quite
helpful. It does not show the holes, just the component placements.
73,
Don W3FPR
-----Original Message-----
I'm installing T6 (yes there is a god, this is the last of the toroids
for a little bit) and noticed a hole next to Z6. I did not see anything
in the text, but the holes on either side of the can are in the ground
plane so I was not sure.
--
David Wilburn
[EMAIL PROTECTED]
--
No virus found in this outgoing message.
Checked by AVG Free Edition.
Version: 7.5.441 / Virus Database: 268.18.1/690 - Release Date: 2/16/2007
2:25 PM
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
