Having fun learning to operate my recently built K2 #5654. It's a great
rig!
While setting up the scan functions, I notice that the MHz decimal
point flashes when in scan mode, as was stated in some of the
literature that I read. However, in normal mode (not scanning) there is
no MHz decimal point in the display.
Is there a way to have the MHz decimal point in the display when not
scanning?
I read through the manual and could not find any reference to turning
the MHz decimal point on or off. All my other rigs have both a MHz and
kHz decimal point displayed, and I would like to have the same on the
K2.
Any help would be greatly appreciated.
73,
Henry
WA2IRQ
Henry W. Ott
Henry Ott Consultants
www.hottconsultants.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
