That says that you have a problem with either the thermistor board (your previous email indicted thatyou did not), or in the path from the U6 pin 1 output to the varistors. Check the soldering on R19 and those components that are near it (check the schematic to find the other connected components).
73, Don W3FPR > -----Original Message----- > Don Wilhelm wrote: > > Mike, > > > > OK, it appears as though the output and input of U6A is correct > (at least at > > the extreme ends). > > If your PLL range was correct (recheck frequencies at TP3), then CAL PLL > > should run fine. > > > > When CAL PLL starts, the frequency displayed should be near > 12100 kHz and > > count downward from there - the process takes about 8 minutes. > > > Frequency displayed initially is OK, but it doesn't really change at > all. U6p3 decreases steadily (as it should) but p1 is fixed at > about 8 VDC. > > > -- > Immanuel Kant but Kubla Khan. > > 73, Mike > KCØTQX > -- > No virus found in this incoming message. > Checked by AVG Free Edition. > Version: 7.5.446 / Virus Database: 268.18.4/705 - Release Date: > 2/27/2007 3:24 PM > -- No virus found in this outgoing message. Checked by AVG Free Edition. Version: 7.5.446 / Virus Database: 268.18.4/705 - Release Date: 2/27/2007 3:24 PM _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
