Nick:
Thanks for replies to my problem with filters - now sorted and I can
hear the same signal on all filter settings!
Got watts coming out the back but no QSOs - I find that the transmit
freq is more than 1 KHz lower than receive (which is about 2 KHz
lower than the digital display. Can't find anything on the site to
help but yet again sure I am doing something stupid.
Sounds as though there's still(!) an XFIL/BFO alignment problem.
1) Confirm that RIT (or XIT) has not been enabled.
2) What SIDETONE tone (ST P) have you selected?
3) Please send me the CAL FIL DAC (or frequency) values you now
have for both CWN and CW REV. AND the values for the filter
CENTER FREQ. (or DAC value) for each bandwith you've chosen.
4) On what band did you perform the CAL FIL operation? If you did
it on on 15M or above, you MUST INVERT the 'sense' of the side-
bands... e.g. CWN XFIL values will be ABOVE filter center
instead of being BELOW, etc. 40M is probably the best band to
use when performing CAL FIL.
Cheers,
Tom N0SS
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
