hello all,
Well, I hit my first snag with k2 # 5723. On page 61 of the manual in the vco alignment, I measured the voltage of r30 first out at 2.33. that was with the tuning slug, L30 turned all the way in. turning the slug out the voltage changed to 2.44. this is no where near the 6 volts. My question is, the manual says if the voltage does not change, refer to troubleshooting. I can't find anything in troubleshooting that refers to this. With the small change, I am afraid I will need to rewind t5. Anyone have the same problem? Words of wisdom in winding t5/ 73 mike ku4yp _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com