Clark,
You must be doing an inventory for the control board - the front panel
has no RP3 and the RF Board has the thermistor board in place of RP3.
On the R-Paks, the last 3 digits of the number on the body are
significant. In the case if CB RP3, it is 47k ohms, so look for a '473'
at the end of the number - that is 2 significant digits (47) plus a
multiplier (3).
The number you quoted either was incomplete or is a component
manufacturer's designation and has no relationship to the Elecraft part
numbers.
73,
Don W3FPR
Clark Macaulay wrote:
I'm buidling my K2 purchased at Dayton and found a problem when doing a parts
inventory. The Parts List designator for RP3 is far different than the part I
received: it says 806345. Does anyone know if this is a acceptable substitute?
There's nothing in the manual/Addenda nor in the reflector archives.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
