Greg I should have been more complete in my statement of the problem. 37.8 ohms in both polarities of the leads is my current measurement.
Arthur VE9BP > > From: Greg Derda <[EMAIL PROTECTED]> > Date: 2007/07/06 Fri PM 02:54:58 EDT > To: Arthur Gunn <[EMAIL PROTECTED]> > Subject: Re: [Elecraft] K2 #6155 Resistance check for Assembly II - U6 pin 9 > low value > > Arthur, > > Hopefully somebody more knowledgeable than I will reply, if they > haven't already. I had a builder-for-hire help me via email during my > build of K2 #6100. Although mine passed all the tests, he did tell me > that the resistance readings can be anywhere "over" the specified value > (e.g., several of mine were magnitudes greater), but that they should > "never" be below the indicated value. My guess is that you do have a > problem that needs further investigation. > > Good luck and 73, > Greg > ki4mmm > > > > On Jul 6, 2007, at 1:54 PM, Arthur Gunn wrote: > > > Hi builders > > > > Progress seems fine except for a 36 ohm value measured at U6 pin 8 > > instead of >100 ohms (page 59). What values have you seen there? My > > measurements were made with an Ideal auto-ranging DMM. > > > > I see at least 8 paths plus active devices to be considered for > > troubleshooting if 36 ohms is not a commonly seen resistance reading. > > The other values in the table of resistance checks are as specified. > > > > I look forward to hearing your experiences at this resistance > > checkpoint. > > -- > > Arthur VE9BP > > > > > > _______________________________________________ > > Elecraft mailing list > > Post to: Elecraft@mailman.qth.net > > You must be a subscriber to post to the list. > > Subscriber Info (Addr. Change, sub, unsub etc.): > > http://mailman.qth.net/mailman/listinfo/elecraft > > > > Help: http://mailman.qth.net/subscribers.htm > > Elecraft web page: http://www.elecraft.com > > > Arthur Gunn, P.Eng. A.W. Gunn Engineering 74 Mill Bank Road Nasonworth NB E3C 2C6 Canada P 506.457.2020 F 506.457.2035 [EMAIL PROTECTED] _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
