Hi -
I have completed the RX in my K2 and found that all signals were end-
stopping on the LED. I have recalibrated the segement hi/lo settings
as per the manual but this procedure always results in high readings
(eg. S5 sigs read S40). I can wind s-hi up to make the readings more
sensible and then it all behaves correctly.
I wonder whether I have a wrong capacitor or resistor somewhere, as I
think the calibration process is unlikely to give S40 readings in
this way. I'm not sure where to look - any advice on this would be
much appreciated!
73
Michael G7VJR
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
