Larry:
Any chance your supply voltage is running low?
73,
Steve Kercel
AA4AK
At 08:01 PM 10/8/2007, Larry Naumann wrote:
I sometimes get a HI CUR warning on my new K2. I have the high
current set at 2.5 amps. My power supply is steady but on 40 meters
when the SWR is slightly high but below 2:1, I get a HI CUR when
running 10 watts out. Into a good 50 ohm dummy load I get 2.02 amps
on 40 meters.
I've double checked my output filter tuning and all is good.
Is this something to be concerned about or is this in the normal
range of xmit current at 10 watts?
Larry Naumann N0SA
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com