OK. Honestly I have searched the mail list archives and manuals...and cannot
find the answer....
I have a K2 with 100 w PA (so that serves in place of K102 i/w aux bus), and
the KAT100 tuner. A cable runs from the K2 aux DB9 to the tuner.
Now, I want to run a cable from my computer to allow me to use the K2 Remote
Software.
I have the cable.. but there is no place to put it!!
I assume I have to use some sort of DB9 connector.. but what sort and where
do I plug that it in such that the KAT100 tuner and the computer are
connected?
Does it go in the K2 aux socket and then cables go off to the KAT 100 and
the computer? Or some other way that KAT100 and computer software signals
are sent in a parallel fashion?
If any one would please outline this in some detail or point me to where
this it explained I would really appreciate it. Someone else might too..
since I honestly don't see it anywhere.
But then again, my wife says I don't see things that are in plain sight.
Brien Pepperdine
Toronto
VE3VAW
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
