-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
Colleagues,
I've just finished a KPA100 and am in the process of doing the final
checkout.
I've made it past the bias adjustment stage and the power supply test
stages.
Below 11 watts output (PA switched out) everything seems to work OK.
Setting the power output to 20 watts and pressing tune results in NO
power output and a current draw of approx. 26 amps. Not good.
I checked recent posts regarding this problem but none seem to have the
high current problem associated with no KPA output power.
Suggestions?
Thanks a mil,
Ron
- --
- -=-------------------------o---------------------------=-
Ron Hahn, EI2JP | Grid Square: IO62TG
Rose Hill | Fists: 10883
Rosslare Strand | QRP-ARCI: 12584
County Wexford, IRELAND | K2: 4922
__+__
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.7 (Darwin)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org
iD8DBQFHUxrDyJCeYjZnfkQRAkvbAJ9iHe9PVXg1HCZoxVzRWLCs+1x3ywCfRguC
1JTrn0xszgOQi8f7RslQwLY=
=WKQo
-----END PGP SIGNATURE-----
--
This message has been scanned for viruses and dangerous content by MailScanner,
and is believed to be clean.
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
