RC,
The PLL is just fine, but the VCO is not on the proper frequency - and
that fact is why the voltage at R30 does not adjust - it is simply too
far out of the expected frequency range.
It sounds like C71 is not actually connected in the circuit. Check the
soldering, particularly in the VFO Range Selection area. Look at the
schematic (RF Board sheet 1) to identify the components connected to
relays K13, K14 and K15. Be certain those relays and varactors are
oriented correctly.
73,
Don W3FPR
Robert 'RC' Conley wrote:
PLL Referance Oscillator Range test page 63 "G" Manual
Hi freq=12098.28
Lo freq=12083.48
range=14.76
Range must be between 9.8 and 15Khz
-----
VCO
CAL FCTR Test TP1 should see reading between 8 and 10 MHZ
actual reading is 18, 493.77 MHZ
I think this is a little high
----
VCO voltage does not adjust
DMM flickers at 0.017 / 0.18 vdc
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
