Make sure the bit jumper block is in (connects the PA's power). Also, make sure your filter(s) are set up properly. Make sure the filter you want to use for transmit is enabled, etc.
matt - WA6EGJ k3 # 24 On Sat, 15 Dec 2007 20:16:32 +1300, you wrote: >Good afternoon/evening fromZL > >We have assembled the k3 and run the initial test stages and have run into a >problem. > >During the lowpower wattmeter calibration we appear to have no TX output. > >Test indicate no RX either. > >Yes we have upgraded to the latest firmware, 01.49 > >Any suggestions??? > >Peter ZL1PWD > >K3 #0139 >_______________________________________________ >Elecraft mailing list >Post to: Elecraft@mailman.qth.net >You must be a subscriber to post to the list. >Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > >Help: http://mailman.qth.net/subscribers.htm >Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
