K3 #157 (factory-assembled) ordered on May 2 arrived on Xmas eve. Here's my question. How do you connect an ICOM PW-1 amplifier to the K3. I know that the ALC is a yet to be resolved issue. I have an IC756ProIII already connected to the amp so the K3 will be the second exciter. Has anyone connected a PW-1 to a K3 yet? I have to run a cable from the send2 connection on the PW-1 but what does it connect to on the K3. There are no amplifier connection diagrams in the K3 manual (yet, anyway!!)
Incidentally, in a side-by-side comparison, the K3 receiver wins hands-down - no contest. I really want to try the K3 with the PW-1 in the Stew Perry Challenge this weekend. John K8WDN K3 #157 K2 #85 -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of David Ferrington, M0XDF Sent: Thursday, December 27, 2007 4:47 AM To: elecraft@mailman.qth.net Subject: Re: [Elecraft] Amplifier Hook Up That PTT RCA socket is an INPUT - to close the PTT line - ie it puts the K3 into transmit. On 26/12/07 19:16, "Dave G4AON" <[EMAIL PROTECTED]> sent: > I use my K3/100 with an Acom 1000, I just connect the phono keying > output to the amplifier keying input with a phono to phono screened > lead. The Acom doesn't have ALC output, so it's not an issue. The > K3/Acom combination works great on CW with no relay thumps or clicks > from the almost silent vacuum relay in the Acom linear. > > The ALC input to the K3 is positive going (0 to + 5 Volts on pin 15 of > the Aux I/O socket) and has been discussed on the Reflector previously. > > 73 Dave, G4AON > K3/100 #80 > ================ > > When examining the back panel of the K3 I see an output for PTT to control an > amplifier but I don't see any input for the amplifier AGC output to control > the transmitter power. Surely this common feature was not overlooked on > such a feature rich transceiver. Where is the connection for this control > and what control voltage is it looking for? I don't see an amplifier hook > up diagram in the manual either. Surely someone using this transceiver with > an amp! -- Man is the best computer we can put aboard a spacecraft and the only one that can be mass produced with unskilled labour. -Wernher von Braun, rocket engineer (1912-1977) _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com