I thought these kinds of questions were supposed to be posted to the K3 support email list.
Stan Rife W5EWA Houston, TX K2 S/N 4216 -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Eric Swartz - WA6HHQ, Elecraft Sent: Thursday, January 03, 2008 11:51 AM To: David Ferrington, M0XDF Cc: elecraft@mailman.qth.net Subject: Re: [Elecraft] Re: K3 NB indicator flasjing I believe this indicates that you have set the H/W NB threshold or width to too high of a value for your current noise or signal levels, which has the noise blanker activated a majority of the time. This will usually cause an unacceptable amount of intermodulation from adjacent signals. Reduce the threshold or width setting to eliminate the flashing. 73, Eric WA6HHQ --- David Ferrington, M0XDF wrote: > You know, this thread is all well and good, but no-one has yet > answered the original question :) > > Which is: > > >>> I might have missed this in the manual, but when I change the NB IF >>> width value, I can get to a point where the NB flashes - what does >>> this indicate? >>> > > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
