Not sure if you order from Heil if you get an adapter with it, but the
Elecraft ProSet-K2 comes with an adapter to go in front Mic connector and it
has a 1/4" jack for PTT.

Note also that the Elecraft ProSet-K2 has an Electret mic (it's effectively
the Proset iC), whereas the Prosets from Heil have HC4 or HC5 elements.

Heil sell a foot switch and a hand switch - I have both and wasn't sure
which I preferred.
You could make one too if you wished.
There is also a PTT RCA connector on the rear panel, so you don't need to
use the front Mic connector.

BUT, I now have the Proset connected to the rear 3.5mm jacks for Phones and
Mic and use VOX, which is so good on the K3, no discernable delay in the
VOX.

I will probably keep the PTT etc. when I run JOTA, I need to keep control of
the PTT, so using a Heil HM-10 on a boom with a PTT switch works well.


On 30/1/08 03:23, "Brett Howard" <[EMAIL PROTECTED]> sent:

> So if I order the Heil headset for my mic w/ the K3 what do I need to buy to
> have a PTT button?  I'm assuming that there are footswitches for this but
> not sure what the best bang for the buck type stuff would be.  What jack
> does this plug into?  My hope is that I can use the Elecraft/Heil headset
> and have a computer interface and a keyer and possibly transverter without a
> cable plugged into the front.  Seem possible?
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft@mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com

-- 
Ok, so what's the speed of Dark?


_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com

Reply via email to