-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
The version showed as "109."
The PFn menu item was set to the ATU. I never set up the PFn to
anything. After reseting the PFn to "nb" (which I don't have installed)
the RIT turns on when the menu is ATU > Out. So, problem solved.
Thanks, Brett. Still strange that the PFn was set w/o my intervention.
--
MGFoster:::mgf00 <at> earthlink <decimal-point> net
Oakland, CA (USA)
KI6OFN
-----BEGIN PGP SIGNATURE-----
Version: PGP for Personal Privacy 5.0
Charset: noconv
iQA/AwUBR7KNyIechKqOuFEgEQIWMwCfRjenBA60PEOQI7IzV854XY+UZLkAniIJ
ZAIU6lSbNfoZoCkV90Dir+Uc
=ZeFC
-----END PGP SIGNATURE-----
Brett Howard wrote:
When I set my tuner to out I have no problems turning on RIT. Are you
sre you aren't selecting OUT for PFn and are holding the RIT/XIT(PFn)
button to get to the OUT menu element?
What is your PFn menu item set to? When you hold the RIT button what do
you get? Also what firmware revision are you running? Hold down
band/display when powering up the unit. When its up the ATTN light will
be lit. When you release the button it will display the firmware rev
for a bit.
On Mon, 2008-02-11 at 12:57 -0800, MGFoster wrote:
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
While operating on 40 meters I tried to turn on RIT - instead of turning
on, the menu displayed the "Out" menu item. I had the Attenuator on, so
I turned that off, yet still the "Out" appeared on the menu when I tried
to turn on RIT.
Later, by experimentation, I discovered that when the ATU's sub-menu
"Out" is selected the RIT won't turn on. If some other menu item is
selected the RIT will turn on. Is this a feature, or have I crossed
wires somewhere?
Thanks,
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
