Bill, I have exactly what you saw. Having reduced freq from above 25MHz there was still no output even though I was now in the 12m band. QSY to within any other band and still no output. How strange! I'm using latest firmware etc.
As with you, TX was restored by changing the power level. And the radio works fb otherwise. So you are not alone...! 73 Stephen G4SJP On 4/3/08 22:12, "Bill Coleman N2BC" <[EMAIL PROTECTED]> wrote: > Bear with me, this is strange.... K2 / 06254 built last Fall > > A few days ago I fixed a problem on my K2 (low output on 15/12/10). > Yesterday I finished a complete alignment and today reinstalled the KPA100. > > So... its lashed to a dummy load and I'm stepping through the bands to make > sure the KPA100 is happy. I get to 12M and the VFO happens to be set to > 25000.00, I tap the key. No output and I get an "END" message on the > display. > > Move the VFO to inside the band, no more "END" message but still no output. > Change the power level - now there is normal output! > > In fact, if I recreate the setup (freq to 25000.00 or higher, tap the key, > get "END"), then change to any other band - there is no output until I > change the power setting. > > I couldn't find this mentioned in any of the archives. Is the firmware > getting confused or do I have a unique gremlin? The only reference to the > "END" msg I can find in the book is CAL PLL. > > It's working 100% otherwise. Would appreciate it if somebody else would > give this a try! > > THX & 73, Bill N2BC > > > > > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
