Hi all, In the process to test and alignement Part II, I have the following issue: I don´t get the correct range of BFO values. In my case the set of values are:
- Using CAL FCTR ........... 4913,63 Khz. - BFO High Freq. .............. 00000,00 - BFO Low Freq ................ 4912,60 Khz. When I try to set up all filters following the instruccions on page 93, I have got the correct values in CW Norm. and LSB modes, but I can´t get the correct values in CW Rev. / USB modes. The maximun value that I can get in this modes is 4914,00 Khz. The rest of tests included in this section are corrects Note: In my K2 kit I don´t received ( or I have lost it ) the diode D36 - SMT1B and I have replaced it (temporarily) for an IN4007. Could be this change the reason of my troubles ???. Of course, I checked and re-checked the values and solders of all the components involved in the BFO schematics ( L33, D37, D38, C169, C173, C174, X3 and X4 ) All suggestions will be appreciated. 73´s Toni, ea3gby ( K2 - s/n 6379 in building process ) ____________________________________________________________________________________ Looking for last minute shopping deals? Find them fast with Yahoo! Search. http://tools.search.yahoo.com/newsearch/category.php?category=shopping _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com