With the FM filter in slot 1 and the 2.7 kHz filter in slot 3 (slot 2
empty). The latest firmware is installed:
I go to any band and select USB. The rig is set at 6.0 kHz bandwidth
and FL1 is selected. I change it to 2.7 kHz and FL3.
I then go to CW on another band. When I switch back to the original
band and back to SSB, the rig is once again at 6.0 kHz bandwidth and
FL1. If I am reading the manual correctly, shouldn't it remember the
previous settings? I tried turning "off" FL1 for USB and LSB and it
didn't make any difference.
I have only a few hours in the pilot's seat, so it is quite possible I
have something misconfigured, although I have been through the filter
settings a half-dozen times. Anyone have any ideas as to what might
be wrong?
Thanks and 73,
John, WA6L
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com