An easy way to set up your filters correctly & quickly is to go into the K-3 Utility, go to configuration, click edit crystal filters, once there make your edits and click ok and it will make the changes right away to your rig.
Jim -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Ed Muns Sent: Saturday, April 12, 2008 2:42 PM To: 'n4lq' Cc: Elecraft@mailman.qth.net Subject: RE: [Elecraft] 6 khz cw question? > I have the 6 khz filter in slot #1 but in cw mode it skips to > slot #2 restricting my receive BW to 2.7 khz. Is this the way > it's supposed to work? > If so, why? I want to hear more BW in CW mode and don't want > to be switching to LSB just to listen. > Also, is there any reason why I should not choose the 6 khz > filter for transmitting CW from the menu, FLTX CW? Do you have FL1 (6 kHz) selected for CW mode in the filter parameter in CONFIG? When the FL1 parameter is selected in CONGIG and you are in CW mode, it should indicate 'YES' rather than 'NO'. For TX, use only the 2.7 or 2.8 kHz filter for CW, SSB and DATA modes. Selecting any other TX BW will generate a TXF error on transmit. Wayne may broaden the choices for TX filter bandwidths in the future, and if anything the CW TX bandwidth choices will be lower, not greater. 73, Ed - W0YK _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
