I'm getting 100 watts out with 100 watts requested, 120 watts out with
120 watts requested.
73,
Ken K3IU
K0EKL wrote:
After doing the full calibration multiple times (Synthesizer/Wattmeter/TX
Gain/ and TCXO) I find that I have lower than expected power output on 6m.
Firmware is 1.78 and I have the rig set to transmit through the 2.8 KHz
filter.
With the K3's power set to 100 watts I'm seeing 66.3 watts output to a dummy
load on my LP-100A wattmeter. Set to 120 watts I see a maximum of 76 watts.
Is this normal behavior?
Thanks.
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
