Hi Jim,
Yes, Wayne says they are going to support L18 with some RTV or something
similar like the ones on the PA.
In a weird way I think this was meant to be, I haven't built one of Wayne's
rigs yet without winding a toriod, hihi.
73 de jay/w5jay..
The broken wire on the toroid seems to be a common problem. Are steps
being taken to add some support for this component during shipping?
Jim K4JAF
Well K3 #850 is alive and well. Only two problems, KBPF3 filter PCB had
L18 snapped off and one lead was cut. So I unsoldered the remaining
lead, rewound it, resoldered it to the board, and installed the board at
the same time as the KPA3. The other problem was a small scratch on the
bottom back cover, which I am sure they will replace. I am not worried
about that at all.
All the stuff I was worried about like Anderson Power Pole plugs,
rattling headphone washers, turned out to be no big deal. Yes I had to
redo some steps if I wasn't looking ahead. As I was assembling the front
panel I notice their was some room that would cause the headphone washer
to rattle, however if you gently push in on the front panel while
tightening up the headphone nut with my fingers it took up all the slack.
This pressure keeps the headphone nut from backing out.
It took me a day to build the rig, a day to finish up the loose ends and
do the cals, install the PA, redo the BPF toriod. I took my time and
enjoyed the experience over the weekend while attending to call outs from
work.
I sent one email to Elecraft tech support today about the KBPF3's toriod,
not really expecting a reply until Monday. WoW right in the middle of
all this software upgrade stuff, I got an email from Wayne. Thanks Wayne
for taking the time to answer my questions on how to get L18 going again.
First contact as a QRP rig was KA8CPO on 40m CW, second contact was with
G3LNP on 40m SSB running 100 watts into my inverted Delta loop.
The K3 is a very good experience so far!
Order it on 11/27/07
Estimated delivery mid February
Got Katigram on 04/25/08
Received it on 05/0208
I almost want to sell it and order up another one. Building and messing
with this little rig a ton of fun! Maybe later, time to get on the air
with this one! :-)
73 de jay/w5jay..
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com