John,
That behavior will be corrected, I know it is on the list. I recall
that there has been discussion about just where inside the ham band the
band button will place the K3 - i.e. if you tune out of the band at the
bottom end, return to the lowest frequency in the band? if you tune out
the top of the ham band, then do you return to the top of the band? Or
should it return someplace else - everyone will of course have their
favorite answer on this one.
Until it is settled and is coded into firmware, Direct Frequency Entry
will get you back into the ham band. If you have set up a memory for the
ham band in question, a tap of the M>V button will do it - both these
solutions are easier than twisting the VFO knob until it is back in the
ham band.
73,
Don W3FPR
John H Gibson wrote:
Question for the list:
On my K3 (SN 820) I have noticed that if I tune to frequencies between the ham
bands (e.g. WWV frequencies), these frequencies then show up when I step the
band switch up and down. Is there a way to delete this out-of-the-ham-band
clutter from the band switch's operation?
My K3 still has the version 1.78 control firmware that it came with.
73,
John, no8v
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com