-----Original Message----- From: Tom Doligalski [mailto:[EMAIL PROTECTED] Sent: Sunday, June 08, 2008 7:29 AM To: 'Dave G4AON' Subject: RE: [Elecraft] K3 Beta Firmware Revision 2.02
I think you'll find that Channel Hopping on the K3 will work just as you wish.... try this: 1. Load your frequencies in consecutive memory channels, being sure to use the asterisk "*" text label. 2. Recall any one of these using M>V. 3. Now, just use VFO A to cycle through your consecutive frequencies... 73, Tom W4KX -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Dave G4AON Sent: Sunday, June 08, 2008 2:08 AM To: elecraft@mailman.qth.net Subject: [Elecraft] K3 Beta Firmware Revision 2.02 "Channel hopping" doesn't seem to offer anything useful to me. It would have been nice if rotating VFO A not only displayed the frequency stored but instantly assigned it to a VFO so the K3 could be used in the same manner as a crystal controlled transceiver (without having to press M-V again). As the K3 lacks a V/M switch, I guess it will not operate in a channelised manner any time soon. 73 Dave K3/100 #80 ---------------- K3 beta-test firmware revision 2.02 is now available. It includes one new feature (channel hopping, especially useful on 60 meters) and a correction to CW/VOX behavior. _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com