----- Original Message ----- From: "Dave G4AON" <[EMAIL PROTECTED]> To: <elecraft@mailman.qth.net> Sent: Saturday, June 14, 2008 5:10 PM Subject: [Elecraft] Fw: K3 - SSB levels
| Julian | | I've noticed a similar odd issue when using the Winlink program | "Airmail", after quitting the HF module the K3 is returned to it's | original frequency but with the 6 KHz bandwidth filter instead of the | 2.8 KHz one... Rather strange as on USB that filter is not enabled. | | 73 Dave, G4AON | K3/100 #80 MCU f/w 2.02, DSP f/w 1.78 | ------------------------------------------------------- | | Do either of you guys use computer software to control the radio, perchance? | I recently identified a problem where filter settings were not properly | being stored or restored when changing bands by software command. Perhaps | other settings are getting lost or confused as well. | | ----- | Julian, G4ILO K3 s/n: 222 K2 s/n: 392 No, I've got a box with knobs and buttons on and I prefer to twist and push them. Computer is only used for logging. The only time I use it to control the radio is spots and in contests for requested QSYs. Regards, Mike VP8NO _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com