Hi,
Page 18 of my K3 manual shows the breakout for the RS232 connector. It says
pin 6 is RTS. I thought RTS was on pin 7 in the standard DB9 configuration.
Second question: The manual is clear that pin 1 of the Aux I/O connector is
for FSK IN. Does that mean that I run my computer's RS232 pin 3 (txd) or 4
(dtr) through a NPN level adjuster, or either?
Third question: I am confused because I read (in the manual) that Config:
PTT-KEY settings address only OFF or DTR/RTS or RTS/DTR. No mention of TXD.
Does KEY relate only to CW and not FSK/RTTY?
Just another non-computer jock trying to keep up.
This reflector, Elecraft, and the K3 are just great.
73, Steve, K4FJ
K3/#290
**************Gas prices getting you down? Search AOL Autos for
fuel-efficient used cars.
(http://autos.aol.com/used?ncid=aolaut00050000000007)
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
