Hi Folks, Has anyone set up the jumpers on a K2 for an Icom SM-6? The desk microphone has an internal preamp. The KSB2 manual says:
"Do not connect pin 2 unless mic has internal preamp. Touch-tone ICs may be sensitive to stray RF. Resistor, AF to 5V: HM-7, 820 ohms; HM-12/22/23/36, 10 K. I am assuming I should just connect the 5V to pin 2 If possible I would like to be able to use the HM-36 as well. Should I use a resistor? Thanks in advance, George _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
