Ok then so you don't have that problem... Do you have an oscilloscope handy? Or can you take a measurement with your RF probe on pin 6 of the reference board? Take a measurement on both pin 6 and pin 8 of the connector where the reference board meets up with the RF board if you can...
-----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of OE5CSP-Chris Sent: Tuesday, July 08, 2008 9:51 AM To: elecraft@mailman.qth.net Subject: Re: [Elecraft] Low sensitivity and low power calibration failure ?This is in a completely different area but trust me on this one... See if you can find R66 on t he bottom of the RF board toward the right side of the unit when you're looking at the unit from the front. Its just above Q8 and Q9. Measure the resistance of R66 and post that here. Hi Brett, R66 is about 15.3 ohm 73, Chris -- View this message in context: http://www.nabble.com/Low-sensitivity-and-low-power-calibration-failure-tp18 335793p18343812.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com