According to the manual: MISO line stuck low (asserted) * De-install option modules one at a time. If no failing option module can be found, there may be a problem on the RF board.
Chad WE9V On Sat, Jul 12, 2008 at 2:19 PM, Dave Hachadorian <[EMAIL PROTECTED]> wrote: > Just finished building K3 sn 1176. When I went to do the reference > oscillator calibration by zero-beating with WWV, I found that the receiver > is deaf. Even with a large antenna connected, there is no increase in > background noise, and no signals can be heard. > > When I turned the K3 off and then on again, it came up with ERR IO1. Scary > stuff. Any suggestions? > > Thanks. > > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
