Brett and Don, I wasn't really complaining - it just didn't make sense to me. I should have remembered to RTFM. Thanks for reminding me. Now to figure out how to use that feature to make working DX easier...
73, Bud N7CW -----Original Message----- From: Brett Howard [mailto:[EMAIL PROTECTED] Sent: Monday, July 14, 2008 8:13 PM To: [EMAIL PROTECTED] Cc: Bud Semon N7CW; elecraft@mailman.qth.net Subject: Re: [Elecraft] [K3] RIT Operation Question It should also be noted that holding clr zero's the offset but adds the offset to the current VFO freq. On Mon, 2008-07-14 at 23:04 -0400, Don Wilhelm wrote: > Bud, > > It works just like the manual states. "Tap CLR to zero the RIT/XIT > offset. Tapping it a second time restores the offset." - see the manual > page 22. > > While your comment makes some sense, this is the first time I have heard > anyone complain about teh original operation of the CLR control. > > 73, > Don W3FPR > > Bud Semon N7CW wrote: > > When I have the RIT on and I press CLR, the RIT is cleared. So far so good. > > When I press CLR again, the original offset reappears. I would expect that > > pressing CLR a second time would just verify the frequency delta is 0. If I > > want to switch between an offset and none, I can turn the RIT on and off. > > Is there a feature here that I'm missing? > > > > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com