K3 beta-test firmware revision 2.22 is now available. Details appear
below.
For instructions on how to load beta firmware, please see:
http://www.elecraft.com/K3/k3_software.htm
73,
Wayne
N6KR
* * *
MCU 2.22 / DSP 1.88, 7-28-08
- CHANNEL SCAN no longer locks out small encoders (during scan or after
stopping it). (Channel scanning is most often used on 60 meters; refer
to the owner's manual for details.)
- USER-DEFINED “NORM” VALUES are now referred to as "NORM1/2" rather
than "ALT1/2" to avoid confusion with the “ALT” switch (alternate
mode).
- FLASH MEMORY INITIALIZATION corrected to prevent spurious “FPF LOAD
PENDING” messages. If this message does appear unexpectedly, tap any
switch to see the flash read exception code, e.g. “FPF 1”. Report this
to customer support.
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com