Ron & Don
Does this mean there is a degree of Mojo to found in the K3 after all this
wonderful dialogue of why this or that nit doesn't work?
I certainly hope so My K2 and K1 are sitting here doing the Mojo thing every
time I turn them on.
Guess I can now entertain thoughts of getting a QRP K3 to round out my
family of Elecraft products.
Been holding off as I have been known to whine with the best of the best
about truly insignificant things in the past.
And then finding it was due to my repeated lack of following the directions
in the manual (you know RTFM) that was causing me to go astray.
Also found out that by not starching the briefs the personal stress factor
was greatly reduced as well, but that's another story.
so back into the wood work I go.
Ralph Stetson, KD1R
NW VT
----- Original Message -----
From: "Ron D'Eau Claire" <[EMAIL PROTECTED]>
To: "'Don Rasmussen'" <[EMAIL PROTECTED]>; <elecraft@mailman.qth.net>
Sent: Sunday, August 10, 2008 3:17 PM
Subject: RE: [Elecraft] K3 w/Aluminum Spinner?
Gee, Don, his comment might have been a bit abrupt, but keep in mind that
many members of this list are on dial-up. Some even pay for each byte
downloaded no matter how fast the connection.
It does seem that 2,000 by 3,000 pixel WEB image is a bit "overkill".
Nice disk though.
Experience with the K2 suggests that when an Elecraft rig reaches the
point
where people start fiddling with the knob aesthetics, it's "arrived"!!
73,
Ron AC7AC
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
