Every now and then, I read every message placed on several ham radio reflectors. I am astonished at
1. the high level of detail that some hams worry about and 2. the low level of basic knowledge that the ham test should have caught and finally 3. the seeming unwillingness to just go ahead and try something instead of asking "permission" from "those who know more" (see the quote marks?). HAM radio: in the golden days of the 1956 sunspot peak, hams threw wires in trees, loaded up metal drain downspouts, ran something until it smoked and then wired in something of higher capacity and ran it again. In those days, I never hrd anyone asking if something will work perfectly (after extensive computer modeling, etc.-- yes, I know there were no home computers then) or if some hot shot op already had the thing under discussion. Then, hams just did it. I long for those days, so lacking a time machine, I will just again use the delete function more often. 73 Charles Harpole [EMAIL PROTECTED] > From: [EMAIL PROTECTED] > To: [EMAIL PROTECTED] > Date: Sat, 16 Aug 2008 13:51:49 +0100 > Subject: Re: [Elecraft] K3 Headset Audio - Is this correct ? > CC: elecraft@mailman.qth.net > > Thanks to all who replied. > Yes, I know that it works OK with SPKRS=2, however I would like to > use SPKR=1 so that I can have both the main and sub RX audio > coming from the internal LS. > However, I would also like to use the headphones at the same time, > even if it is a combined audio to both left and right phones. > > Maybe the routing of the headphone audio is such that it is not > possible to do the same with both the LS and headphones selected > without only 1 headphone channel being active. > > 73 > Stewart G3RXQ > On Sat, 16 Aug 2008 06:54:14 -0400, Ken K3IU wrote: >> Try it with CONFIG:SPKRS set to 2. Works here. >> 73, >> Ken K3IU >> >> Stewart Baker wrote:> Since fitting the 2nd RX I have been > exploring the audio >> settings and find that:- To get 1st & 2nd RX audio thru the > speaker I have SPKRS=1. >> This is fine, however if I have SPKR+PH=YES, then I only get > audio from the LH >> headphone. With SPKR+PH=NO, I get audio from both LH and RH > headphones. Is this correct >> ? I am using a Heil PRO headset. 73 Stewart G3RXQ >> _______________________________________________ Elecraft mailing > list Post to: >> Elecraft@mailman.qth.net You must be a subscriber to post to the > list. Subscriber Info >> (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft Help: >> http://mailman.qth.net/subscribers.htm Elecraft web page: > http://www.elecraft.com > > > _______________________________________________ > Elecraft mailing list > Post to: Elecraft@mailman.qth.net > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
