Having successfully installed the KRX3 I have a small problem on the
front panel which I think is due to either a poor ground connection or a
connector not fully mated.
On power all display segments show, which I can't remember seeing
before. Initially I could then see a lot of segments which cleared when
I pressed on the FP. Now I am seeing less unwanted segments which clear
when I press the left hand side of the FP, just to the rioght of the
headphone jack.
Before I take the FP off again has anyone an ideas where I should
concentrate on? Obviously around the left hand side but anything in
particular!
The 2nd Rx sounds great.
Chris G3SJJ
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
