I installed the KPA3 amp module and I've tried to calibrate the PA Temp.
sensor, but cannot get the setting to go below 87 degrees C turning the
VFO A dial. Although the dial continues to turn, the temp. setting will
not go lower than 87. (FWIW Highest it will go is 127 - not sure if
that's relevant.)
I've checked and confirmed the following:
1. Tech MD is set to "on"
2. KPA3 is set to "PA nor"
3. I did not have the rig on all day and the temp. of the room is about
24 degrees C. As soon as I turned the rig on, I immediately went to the
PA Temp setting on the Config menu.
FP Temp is reading correctly at 25. The fans come on as soon as the rig
is turned on.
Any ideas?
Ann VA3NOE
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
