My reason for troubleshooting is there is NO SOUND. I can hear the sidetone when I turn it on. I cannot hear the 7000hz tone.
1. My reference oscillator output is 0.511.a little low. 2. VCO output is okay. 3. BFO output is okay. 4. Mixer, I.F. amplifier, & Crystal filter = 0.00 vdc. So, I started with the control board. U1 voltages are okay. U3 voltages are okay. U4 is a little low at 7.80 vdc. U5 is perfect. U6-U10 are okay. The problems: 1. U2 voltages are around 3.27 vdc instead of 6.9 vdc input voltage is 7.80 on pin 8. I didn't want to move on to the RF board without finding the problem with the Control Board. Do you have any suggestions for finding where the U2 voltages are dropping off. When I adjusted the AGC in step 5 page 48, I was only able to get 3.71 vdc. Ron, KE5QDA
_______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
