Lew,
The mic cable shield should be connected to the shield of the mic plug,
and in turn the mic jack shell should be connected directly to the
enclosure by a very short path. Unfortunately, that does not happen in
most ham gear constructed on PC Boards - it is easy to connect the shell
to the board ground, but that is the wrong place, it really should
connect directly to the metal enclosure for best RF prevention. See Jim
Brown's (K9YC) frequent posts referencing 'the pin 1 problem'.
The shield should not be used for any of the signal returns. Normally
the PTT return connects to pin 7 and the AF return connects to pin 8.
lew wrote:
Does the Elecraft require a microphone ground as well as the usual
ground for its microphone connector? If so, should it go to to pin 7
or 8 on the Elecraft mike connector? If not, are both ground
connections necessary to be made to pins 7 & 8 in the connector?
Thanks,
Lew W7EW
#1560/1561
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com