Initially this KAT2 worked well, switching between ant1 & ant2. During
a lighthouse portable weekend, in hard driving rain, it may have
suffered from a precipitation static discharge via the connected
antenna. Since then, ant2 is always connected. The K-2 (#6155)
otherwise operates normally.
Believing that relay K18 may have had contacts damaged, it has been
replaced but with no change in operation.
Operating the switch for ant1 to ant2 results in a relay operation
sound. Measuring the contacts confirms that the K-18 does not change
position. The tune function operates normally.
In troubleshooting, the DMM indicates the K-18 coil pin 10 to ant
connector shell ground reads 208 ohms while the same reading for K-17
shows 24 ohms.
While tuning the connected antenna: K-18 coil pin 10 to pin 1 reads a
transient 200 mV and K-17 similar reading is a transient 10 mV. The
two relay coils measure about 245 ohms each.
Should I assume that U1 is failing to provide the signal to K-18 and
the relay sound is from another relay possibly also due to U-1 fault?
Your thoughts are appreciated.
Arthur VE9BP
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com