I just installed the KRX3 and upgraded to the latest firmware (MCU 02.46 & DSP 01.92, from 02.10/01.81). Now the power calibration is way off. Even adjusting CONFIG:WMTR LP and CONFIG:WMTR HP to the end of their range (180) I can't get the power low enough. For example, setting 75 watts gives about 100W output on an external wattmeter. A 5W setting gives about 7W output.
I'm almost certain this problem did not exist before I upgraded. Anybody have any ideas? Al N1AL _______________________________________________ Elecraft mailing list Post to: Elecraft@mailman.qth.net You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com