My DSP board failed 4 months after the kit K3 #818 was assembled.
I had no audio anywhere. The S meter showed almost full scale. The receiver
resting current went from .85 to 1.01 amps. Replacement KIO3 boards did not
cure the problem. Gary at Elecraft suggested it might be the DSP board if the
KIO3 boards did not solve the problem.
I sent the rig to Elecraft for warranty work and it was the DSP board. Great
service from Elecraft and Gary by the way.
Since the QST review of the K3/100 also had an audio failure along with a few
reported on the reflector, I wonder if there is a design/reliability problem
here?
Bob, K9PAG
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
